Products


HR / CR Slitting Line

After centralizing the HR/CR coil with the uncoiler mandrel the coil is mounted on the uncoiler. Then the mandrel is expanded and the snubber roll rotates the coil. Peeler breaks the straps and brings the pre-end upto the Pinch roll. The Pinch roll drives the coil end upto the slitter and then its drive is disconnected. Slitter moves the slitted strips further. Slitted strips are threaded through loop table and drag tensioner into the recoiler drum. Recoiler winds one turn on loose coil.

Then drag tensioner and loop are put into operation. Slitter and recoiler run simultaneously in synchronization. As the coil build up, the recoiler rpm correspondingly goes down to keep desired constant line speed. This process goes on until the end of coil on uncoiler. The slitted coil is pushed on the exit coil car trolley through a pusher plate operated by hydraulic cylinder.

The range of slitting lines offered by us are as mentioned below :-

HR/CR Slitting Line Range :

Range of Capacity 5 Ton – 30 Ton
Max. Strip Width Upto 2000mm
Max. Strip Thickness Upto 10mm
Max. Speed Upto 60m/ min.
Raw Material Used HR/CR/SS/GP
Automation Option Manual /Semi-Automatic/Fully-Automatic

 

Singh Engineering Works

Manufacturer & Exporter Of
ERW Tube Mills & Ancillary Machineries

Singh Engineering Works is one of the leading manufacturers & exporters of ERW Tube Mills, HR/CR Slitting Lines, Quality Control & Testing Machines, Pipe Galvanizing Plant and other ancillary equipments & machineries used for complete ERW Tube Mill plant.

For Any Enquiry
Call Us: 09818302543


© Singh Engineering Works. All Rights Reserved (Terms of Use)